Okatmos star 110
Description
Solvent-free (according to TRGS 610), very low-emission wet bed and pressure-sensitive adhesive for bonding, LVT, homogeneous and heterogeneous PVC flooring in strips and tile format, VCT floor coverings, rubber up to 4.0 mm thick in sheeting and tile format, linoleum up to 3.2 mm thickness as well as textile floor coverings. Okatmos® star 100 Plus can be used as wet bed and pressure sensitive adhesive as well as in the contact method (double-drop). Okatmos® star 100 Plus contributes to the prevention of odors with its antimicrobial properties.
Features
- Short ventilation time
- Solvent free and very low emission
- Universally applicable
- Easy trowelable
- Anti-microbial technology
- Breathe easy technology
- Downloads
- Specifications
Colour Cream white
VOC 0,0 g/L Antimicrobial technology
Yes Recycle content
n/a Application Interior
Tensile strength
Suitable
Minimum floor temperature
59 °F/ +15 °C
Skin over time* / Tack time
Approx. 5-10 minutes
Open time (working)
Approx. 40 minutes (covering dependable)
Ready for installation* After approx. 24 hours Final strength* After approx. 72 hours Floor heating system
Suitable
GISCODE D1 according to TRGS 610
EMICODE EC 1Plus
Storage Store in frost protected area for up to 12 months
* At 68 °F (+20 °C) and 65 % relative humidity. Higher temperature and low humidity decreases, lower temperature and high humidity increases this value respectively.
- Substrate Preparation
The substrate must comply with VOB Part C, DIN 18 365, current data sheet BEB as well as with all technical requirements and must be ready for installation. The surface must be sound and clean. Remove dirt, paint, oil, grease wax and other contamination which might act as a bond breaker. Prepare all non-absorbent substrates with Kiesel suitable primers and level using Kiesel self leveling compounds. Before installing vapor-tight coverings prepare substrate with self leveling compound.
Okatmos® star 100 Plus should be used as a product component together with other Kiesel floor installation system products.
- Processing
Mix Okatmos® star 100 Plus well if necessary. Use appropriate notched trowel to apply the adhesive onto the substrate. Install covering after a drying time of 5 - 40 minutes and roll down. Ensure a full area application on the back of the covering. Technical Data Sheet approx. 30 - 60 minutes. Please follow the installation instructions of the flooring manufacturer, especially the directions for covering acclimation. Weld joints no earlier than two days after the installation.
- Coverage
- 4m2/kg TKB A2/V1
- Packaging
33 x 14kg plastic buckets